mechanical properties	Điều kiện kiểm tra	Phương pháp kiểm tra	BASF MALAYSIA/A3W
Tensile modulus		ISO 527-2	3000 Mpa
Bending modulus		ISO 178	2900 Mpa
tensile strength	Yield	ISO 527-2/50	85.0 Mpa
Nominal tensile fracture strain		ISO 527-2/50	25 %
Tensile creep modulus	1000 hr	ISO 899-1	-- Mpa
Tensile strain	Yield	ISO 527-2/50	4.4 %

injection	Điều kiện kiểm tra	Phương pháp kiểm tra	BASF MALAYSIA/A3W
drying time			4.0 hr
Screw speed			< 18 m/min
Suggested maximum moisture content			0.15 %
Temperature in the middle of the barrel			290 °C
Mold temperature			60 to 80 °C
Temperature at the rear of the barrel			290 °C
Processing (melt) temperature			280 to 300 °C
Hopper temperature			80 °C
drying temperature			80 °C
Temperature at the front of the material cylinder			290 °C
Spray nozzle temperature			290 °C
Residence Time			< 10.0 min

thermal performance	Điều kiện kiểm tra	Phương pháp kiểm tra	BASF MALAYSIA/A3W
thermal conductivity		DIN 52612	0.33 W/m/K
Melting temperature		ISO 11357-3	260 °C
Hot deformation temperature	0.45 MPa, Unannealed	ISO 75-2/B	220 °C
Temperature index - at 50% loss of tensile strength	--5	IEC 60216	147 °C
Temperature index - at 50% loss of tensile strength		--6	IEC 60216	121 °C
Linear coefficient of thermal expansion	23 to 80°C，Flow	ISO 11359-2	7.0E-5 - 1.0E-4 cm/cm/°C
Maximum operating temperature	短周期操作		200 °C
specific heat			1700 J/kg/°C
Hot deformation temperature	1.8 MPa, Unannealed	ISO 75-2/A	75.0 °C

Physical properties	Điều kiện kiểm tra	Phương pháp kiểm tra	BASF MALAYSIA/A3W
Shrinkage rate	横向Flow	ISO 294-4	1.7 %
Stickiness	96% H2SO4	ISO 307	150 cm³/g
Shrinkage rate	Flow	ISO 294-4	1.4 %
Mold Shrinkage - Constrained			0.85 %
Water absorption rate	Saturation, 23°C	ISO 62	8.0 to 9.0 %
Melt Volume Flow Rate (MVR)	275°C/5.0 kg	ISO 1133	100 cm3/10min
Apparent density			0.70 g/cm³
Water absorption rate	Equilibrium, 23°C, 50% RH	ISO 62	2.5 to 3.1 %

Electrical performance	Điều kiện kiểm tra	Phương pháp kiểm tra	BASF MALAYSIA/A3W
Compared to the anti leakage trace index	Solution A	IEC 60112	PLC 1
Volume resistivity		IEC 60093	1.0E+15 ohms·cm
Relative permittivity	1 MHz	IEC 60250	3.20
Surface resistivity		IEC 60093	-- ohms
Dissipation factor	1 MHz	IEC 60250	0.025