So sánh vật liệu
Thông số kỹ thuật
mechanical properties | Điều kiện kiểm tra | Phương pháp kiểm tra | JAPAN POLYPLASTIC/1140A6 |
---|---|---|---|
Bending modulus | ASTM D790 | 13700 MPa | |
tensile strength | ASTM D638 | 186 MPa | |
Impact strength of cantilever beam gap | ASTM D256 | 92 J/m | |
Poisson's ratio | ASTM E132 | 0.4 | |
Friction coefficient | VS.ltself-Dynamic | ASTM D1894 | 0.44 |
Suspended wall beam without notch impact strength | ASTM D256 | 353 J/m | |
bending strength | ASTM D790 | 240 MPa | |
elongation | Break | ASTM D638 | 1.7 % |
thermal performance | Điều kiện kiểm tra | Phương pháp kiểm tra | JAPAN POLYPLASTIC/1140A6 |
---|---|---|---|
Linear coefficient of thermal expansion | 垂直 | ASTM D696 | 0.00007 cm/cm/℃ |
Hot deformation temperature | 1.8MPa,Unannealed | ASTM D648 | 270 ℃ |
Linear coefficient of thermal expansion | Flow | ASTM D696 | 0.000016 cm/cm/℃ |
UL flame retardant rating | UL 94 | V-0 |
Physical properties | Điều kiện kiểm tra | Phương pháp kiểm tra | JAPAN POLYPLASTIC/1140A6 |
---|---|---|---|
Rockwell hardness | M-Scale | ASTM D785 | 100 |
density | ASTM D792 | 1.67 | |
Water absorption rate | 24hr,23℃ | ASTM D570 | 0.015 % |
Electrical performance | Điều kiện kiểm tra | Phương pháp kiểm tra | JAPAN POLYPLASTIC/1140A6 |
---|---|---|---|
Dielectric strength | 3.00mm | ASTM D149 | 12 kV/mm |
Dissipation factor | 1E+6Hz | ASTM D150 | 0.002 |
Surface resistivity | ASTM D257 | 8E+16 ohms | |
Arc resistance | ASTM D495 | 120 sec | |
Dielectric constant | 1000Hz | ASTM D150 | 4.5 |
Volume resistivity | ASTM D257 | 1E+16 Ohm.cm | |
Dielectric constant | 1E+6Hz | ASTM D150 | 4.5 |
Dissipation factor | 1000Hz | ASTM D150 | 0.002 |
Compared to the anti leakage trace index | UL 746 | V |